HP Systems Insight Manager 5.3 Technical Reference Guide

The Cluster Monitor page appears for that cluster.
2. Select from the following tabs available on the Cluster Monitor page. Every tab includes a Problem
Info section that provides details about problems reported on the tab. For example, on the Cluster tab,
this section includes status information if the cluster has a status of anything other than Normal.
Each tab also includes a Last Update field that displays the last time the information on the tab was
updated.
• Cluster Use to view cluster information such as the cluster status, name, IP address, and quorum.
• Nodes Use to view node information such as the node status, name, and IP address.
• Network Use to view network information such as the network status, name, mask, state, role,
and description.
• Resources Use to view MSCS Resource information for the cluster, including the status, name,
IP address, state, group, owner node, type, and drive of the resources.
Related topics
• Cluster Monitor Cluster tab
• Cluster Monitor Nodes tab
• Cluster Monitor Network tab
• Cluster Monitor Resources tab
Configuring cluster resource settings
1. Select Options→Cluster Monitor→Cluster Resource Settings. The Cluster Monitor - Cluster
Resource Settings page appears.
2. Configure MSCS clusters by selecting ALL (MSCS) from the Cluster Type list.
3. From the Resource list, select MSCS.
4. Select Polling and set the polling rate.
HP recommends setting the polling rate to no less than 5 minutes.
5. Click OK to save the changes.
Related procedures
▲ Configuring node resource settings
Related topics
• Cluster table view page
• Using Cluster Monitor
Configuring node resource settings
1. Select Options→Cluster Monitor→Node Resource Settings. The Cluster Monitor - Node Resource
Settings page appears.
2. From the Cluster list at the top of the page, select the cluster, and then select All to configure a resource
in the same way for all clusters . To set polling values for CPU utilization or disk capacity, set the cluster
choice to All.
3. From the Node list, select the node, and then select All to configure a resource in the same way for all
nodes in the selected cluster. As in step 2, you can set some resource attributes only once for all nodes.
As a result, you must select all clusters and nodes. For more information, see the individual attribute
descriptions for a particular resource.
4. To display buttons for resource-configurable parameters, select the resource from the Resource list.
5. Specify resource options.
HP recommends setting the polling rate to no less than 5 minutes.
If you select All from the Cluster list and select CPU or Disk from the Resource list, you can set polling
or threshold values. If you select Polling, set the value, then select Thresholds, set the values, and
298 Tools that extend management