Setting up HP SIM 5.x on an HP-UX Serviceguard Cluster (448492-002, January 2009)
# proceeds with a warning message in the package control script logfile.
CONCURRENT_MOUNT_AND_UMOUNT_OPERATIONS=1
# Example: If a package uses 50 JFS filesystems, pkg01aa through
pkg01bx,
# which are mounted on the 50 logical volumes lvol1..lvol50 for read and
write
# operation, you may enter the following:
#
# CONCURRENT_FSCK_OPERATIONS=50
# CONCURRENT_MOUNT_AND_UMOUNT_OPERATIONS=50
#
# LV[0]=/dev/vg01/lvol1; FS[0]=/pkg01aa; FS_MOUNT_OPT[0]="-o rw";
# FS_UMOUNT_OPT[0]="-s"; FS_FSCK_OPT[0]="-s"; FS_TYPE[0]="vxfs"
#
# LV[1]=/dev/vg01/lvol2; FS[1]=/pkg01ab; FS_MOUNT_OPT[1]="-o rw"
# FS_UMOUNT_OPT[1]="-s"; FS_FSCK_OPT[1]="-s"; FS_TYPE[0]="vxfs"
# : : :
# : : :
# : : :
# LV[49]=/dev/vg01/lvol50; FS[49]=/pkg01bx; FS_MOUNT_OPT[49]="-o rw"
# FS_UMOUNT_OPT[49]="-s"; FS_FSCK_OPT[49]="-s"; FS_TYPE[0]="vxfs"
#
# IP ADDRESSES
# Specify the IP and Subnet address pairs which are used by this package.
# You could specify IPv4 or IPv6 IP and subnet address pairs.
# Uncomment IP[0]="" and SUBNET[0]="" and fill in the name of your first
# IP and subnet address. You must begin with IP[0] and SUBNET[0] and
# increment the list in sequence.
#
# For example, if this package uses an IP of 192.10.25.12 and a subnet of
# 192.10.25.0 enter:
# IP[0]=192.10.25.12
# SUBNET[0]=192.10.25.0
# (netmask=255.255.255.0)
#
# Hint: Run "netstat -i" to see the available subnets in the Network
field.
#
# For example, if this package uses an IPv6 IP of 2001::1/64
# The address prefix identifies the subnet as 2001::/64 which is an
available
# subnet.
# enter:
# IP[0]=2001::1
# SUBNET[0]=2001::/64
# (netmask=ffff:ffff:ffff:ffff::)
# Alternatively the IPv6 IP/Subnet pair can be specified without the
prefix
# for the IPv6 subnet.
# IP[0]=2001::1
# SUBNET[0]=2001::
# (netmask=ffff:ffff:ffff:ffff::)
#
# Hint: Run "netstat -i" to see the available IPv6 subnets by looking
# at the address prefixes
# IP/Subnet address pairs for each IP address you want to add to a subnet
# interface card. Must be set in pairs, even for IP addresses on the
same
# subnet.
#
IP[0]="15.43.209.228"
SUBNET[0]="15.43.208.0"