HP Systems Insight Manager 5.2 Update 2 Technical Reference Guide

However, if systems are connected through a WAN, try a higher value, for example,
10 seconds.
• Retries
The number of additional times after the first attempt is made to communicate with a
system before the attempts stop.
• Read-only community string and Write community string
Note: The Write community string is optional and is required only for firmware updates
on a GbE switch. If you must update the GbE switch firmware, you must first set the write
community string from this page and then run the existing switch update task. Do not set
this feature if the network is not trusted.
A community string sets up authentication that enables or prohibits communication
between the managed system and the Central Management Server (CMS). The community
string of the CMS must match the community string of the managed system. Use the
read-only community string to read variables. Use the write community string to modify
variables. Although only one community is valid for a communication attempt, a system
can belong to multiple communities. However, HP SIM only uses one community string
when communicating with a system.
Hosts files can be used to manually add multiple systems to the HP SIM database. See “Managing hosts
files” for more information.
Command line interface
Use the mxnode command to add, delete, modify, identify, or list systems in HP SIM from the command line
interface (CLI). For assistance with this command, see the HP SIM 5.2 Command Line Interface Reference
Guide at http://h18013.www1.hp.com/products/servers/management/hpsim/infolibrary.html.
Related procedure
▲ Creating a new hosts file
Related topics
• Discovery and identification
• IP ranges
• Using command line interface commands
Managing hosts files
Hosts files are used by manual discovery to manually add multiple systems to the HP Systems Insight Manager
(HP SIM) database and are generally used only one time to import systems.
To use a hosts file to specify systems for an automatic discovery, add the hosts file name to the Ping inclusion
ranges, system (hosts) names, templates, and/or hosts files section of the Discovery page under the
Configure general settings section of the Automatic tab. Enter the following statement: $Hosts_filename
where Hosts_filename is the name of the hosts file that you want to use.
See “Adding a system manually” for information about adding a single system to the database. See the
"Hosts files" section in the “Discovery and identification” section for more information about hosts files.
From the Hosts Files section, you can:
• Create new hosts files Click New. The New Hosts File section is displayed. See “Creating a new
hosts file” for more information.
• Edit a hosts file Select the hosts file to edit, and then click Edit. The Edit Hosts File section is
displayed. See “Editing a hosts file” for more information.
116 Discovery and identification