HP Systems Insight Manager 5.2 Update 2 Technical Reference Guide

ManualsBrandsHP ManualsSoftwareHP Systems Insight Manager for Linux

291

292

293

294

295

296

297

298

299

300

Configuring cluster resource settings

Configure the cluster resource settings to customize

Cluster Resources

for your environment.

NOTE: When using the keyboard to input an alphanumeric character to highlight an option with the arrow

keys in any dropdown list in the Cluster Monitor, press the Enter key to select the item.

To configure cluster resource settings:

1. Select Options→Cluster Monitor→Cluster Resource Settings. The Cluster Monitor - Cluster

Resource Settings page appears.

2. Select ALL (MSCS) from the Cluster Type list to configure MSCS clusters.

3. Select MSCS from the Resource list.

4. Select Polling and set the polling rate.

Note: HP recommends setting the polling rate to no less than five minutes.

5. Click OK to save the changes.

Related procedures

▲ Configuring node resource settings

Related topics

• Cluster table view page

• Cluster Monitor

Configuring node resource settings

Configure the node resource settings to customize

Cluster Monitor

for your environment.

To configure node resource settings:

1. Select Options→Cluster Monitor→Node Resource Settings. The Cluster Monitor - Node Resource

Settings page appears.

2. Select the cluster from the Cluster list at the top of the page. Select All to configure a

resource

the same

for all

clusters

. To set polling values for CPU utilization or disk capacity, the cluster choice must be set

to All.

3. Select the node from the Node list. Select All to configure a resource the same for all nodes in the

selected cluster. As in the case of clusters in step 1, some resource attributes can only be set once for

all nodes and so require you to select all clusters and nodes. See the individual attribute descriptions

for a particular resource.

4. Select the resource from the Resource list to display buttons for the resource configurable parameters.

5. Specify the appropriate resource options.

Note: HP recommends settings the polling rate to no less than 5 minutes.

Note: If you select All from the Cluster list and select CPU or Disk from the Resource list, you can

set polling or threshold values. If you select Polling, set the value, then select Thresholds, set the

values, and then select Polling again. The new polling values are still displayed. No matter when you

click OK after setting the polling or thresholds values, these values are saved and not reset to the original

value, which is the same when setting thresholds.

6. Click OK to save the changes.

Related procedures

▲ Configuring cluster resource settings