HP Systems Insight Manager 7.0 Installation and Configuration Guide for Microsoft Windows

3. Click Install to initiate the installation process. This process installs all the products listed in
the Selected Components table. The Status window appears. As each component is being
installed, it states "In Progress" beside the component's name. After the component has installed,
it states Installed Successfully.
4. After all of the components are installed, click Next.
5. The Registration window appears. Register HP Systems Insight Manager or click Register Later.
NOTE: If you do not have Internet access, click Register Later or navigate to http://
h20293.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=HPSIM-LIC
to register.
When the Install Complete window appears, you are given the option to reboot. The following
message appears: For this upgrade install, HP recommends that you
configure the System Management Homepage to use operating system
authentication for HP VCA.full.name; access to Version Control
Repository Manager, and then re-configure the servers running HP
VCA.full.name; to use the new account. If these actions are not
taken, pre-7.20 Version Control Agents will access your upgraded
Version Control Repository through legacy HTTP Server account access.
For more information, see the Version Control Installation Guide at http://
h18013.www1.hp.com/products/servers/management/agents/documentation.html
6. Click Finish to allow the system to reboot. This completes the typical upgrade process. For
more information, see “Next steps” (page 58).
NOTE: For more information regarding where the System Management Homepage default
settings are stored during a Typical installation and how to change them, see the HP System
Management Homepage Installation and Configuration Guide at http://
h18013.www1.hp.com/products/ servers/management/agents/documentation.html.
Custom upgrade
Procedure 13 Custom upgrade
1. Click Next, the Software Selection window appears. This window displays the complete list
of the available components with a checkbox next to each one. If the checkbox is selected
and disabled, the component is deemed a mandatory component and cannot be cleared. The
amount of required disk space is also listed for each component. Select the components you
want to install.
2. Click Next to verify that enough disk space exists for the selected components. If enough space
exists, the Service Account Credentials window appears. The Domain and User name fields
will default to the installing account credentials. Enter the password for this account. You can
also provide the credentials for a different administrative account.
3. Click Next. The Summary window appears.
NOTE: This user account is used to run the HP Systems Insight Manager service.
52 Upgrading HP Systems Insight Manager