Setting up an HP SIM server 5.x on a Linux-based Serviceguard Cluster 444847-003, March 2009

12
NETWORK_POLLING_INTERVAL 2000000
# Package Configuration Parameters.
# Enter the maximum number of packages which will be configured in
the
cluster.
# You
cannot
add packages beyond this limit.
# This parameter is required.
MAX_CONFIGURED_PACKAGES 20
EOF
3.
Replicate the node
on node SG2hpsimlnx
:
#
scp
-
p $SGCONF/cluster.conf
ig
$SGCONF/cmclnodelist
SG2hpsimlnx:$SGCONF
4.
Apply
the config
uration
:
#
cmapplyconf
-
v
-
C cluster.conf
ig
Begin cluster verification...
Checking cluster file: cluster.conf
Note : a NODE_TIMEOUT value of 2000000 was found in line 54. This value
is recommended if the top priority is to reform the cluster as fast
as pos
sible in case of failure. If the top priority is to minimize
reformations, consider using a higher setting. For more information see
the cluster configuration ASCII file or the Managing Serviceguard
manual.
Checking nodes ... Done
Checking existing configu
ration ... Done
Gathering storage information
Gathering network information
Beginning network probing (this may take a while)
Completed network probing
Checking for inconsistencies
Maximum configured packages parameter is 20.
Configuring 0 package(s).
20 p
ackage(s) can be added to this cluster.
200 access policies can be added to this cluster.
Creating the cluster configuration for cluster sghpsimlnx
Adding node SG1hpsimlnx to cluster sghpsimlnx
Adding node SG2hpsimlnx to cluster sghpsimlnx
Completed the cl
uster creation
5.
To start the SGLX cluster, e
xecute
the following
command on
the
primary
node
:
#
cmruncl
-
v
cmruncl: Validating network configuration...
cmruncl: Network validation complete
Waiting for cluster to form ..... done
Cluster successfully formed.
Check the syslog files on all nodes in the cluster to verify that no
warnings occurred during startup.
Creating the HP SIM package
1.
Launch HP Serviceguard Manager within
S
MH.
2.
Select
Configuration
>
Create a Single Package.