HP TeemTalk Terminal Emulator, version 7.3, User Manual
4. If required, press the Insert key to toggle between Insert and Edit mode, as indicated in the status
line.
5. Make the required changes to the macro.
6. To save the edit, press Alt + F3.
7. Press Quit to exit.
Error Codes
The following error codes may appear on the status line if an error occurs during recording or
playback.
Table 15-2 Recording/Playback Error Codes
9001 Exceeded the maximum number of allowed keystrokes.
Remedy: Press the Record key to exit Record mode. To record a new keystroke sequence, either:
●
Press the Record key and the target Fn key that has erasable data, then enter the new data, or:
●
Press the Record key and the target Fn key that has erasable data, then press the Delete key to erase the
recorded data for that key.
9003 You pressed an invalid Fn key while performing the Record or Play function.
Remedy: Press the Reset key.
9007 You pressed an invalid sequence key (e.g. Play) while performing the Record function.
Remedy: Press the Reset key.
9010 While performing the Play function, you pressed an Fn key that does not have a keystroke assigned to it.
Remedy: Press the Reset key.
9015 In communication mode, you pressed either the Quit or Pause key.
Remedy: Press the Reset key.
9019 In Record or Play mode. While the Record/play pause indicator was displayed on the status line you pressed an
invalid key (e.g. Play key in Record mode, or Record key in Play mode).
Remedy: Press the Reset key.
Notice Board Facility
Introduction
The Notice Board is an area of the display in which copied data can be stored and manipulated. You
can display the Notice Board either by pressing the keys Alt + F2, or by selecting the Notice Board
Enabled option on the Notice Board Settings tab of the 3270 Display Settings dialog (see
Notice Board Settings on page 160).
When the Notice Board is enabled, pressing the Zoom key will toggle the display between full screen
(i.e. the screen currently containing the cursor) and split screen (host screen and Notice Board) mode.
The Zoom Settings options on the Notice Board Settings tab of the 3270 Display Settings
Notice Board Facility
149