HP TeemTalk Terminal Emulator, version 7.3, User Manual

National Settings
These options enable you to select the character set to be used. There are separate entries for the
Single Byte Character Set (SBCS) and (if supported) Double Byte Character Set (DBCS). These should
only be changed by the System Administrator. If they have been changed and you wish to restore the
default settings, click the Defaults button at the bottom of the dialog. The table at the end of this
section shows the default settings.
●
National Codepage Settings
Factory default: User Defined
This specifies the type of national codepage to be used. Selecting User Defined will enable
manual selection of the Codepage, Character Set and Character Set ID using the following
options.
●
SBCS / DBCS Codepage
Factory default: SBCS 37 - DBCS 0
This is a numeric value specifying the codepage to use.
●
SBCS / DBCS Character Set
Factory default: SBCS 697 - DBCS 0
166 Chapter 16 IBM 3270 Printer Emulation