HP TeemTalk Terminal Emulator, version 7.3, User Manual

National Settings
These options enable you to select the character set to be used. There are separate entries for the
Single Byte Character Set (SBCS) and (if supported) Double Byte Character Set (DBCS). These should
only be changed by the System Administrator. If they have been changed and you wish to restore the
default settings, click the Defaults button at the bottom of the dialog. The table at the end of this
section shows the default settings.
●
National Codepage Settings
Factory default: User Defined
This specifies the type of national codepage to be used. Selecting User Defined will enable
manual selection of the Codepage and Character Set using the following options.
●
SBCS Codepage
Factory default: 37
This is a numeric value specifying the single-byte character set codepage to use.
●
SBCS Character Set
Factory default: 697
This is a numeric value specifying the single-byte character set to use.
●
DBCS Codepage
Factory default: 0
This is a numeric value specifying the double-byte character set codepage to use.
●
Font
Setup Options
185