HP UPD - Driver Configuration Support Guide

3. Click Next. The Confirm page appears.
4. Click Next. The Results page appears. Click Done to view the Print Management page.
Driver management
HP Web Jetadmin facilitates driver management. Drivers can be added to the HP Web Jetadmin host
which acts as a driver repository. These drivers are installed on remote hosts where queue
management is being performed. The drivers can be removed when they are no longer the latest
revision or no longer needed. Drivers, once they are listed in Available Drivers, can be preconfigured
to contain settings such as duplex-on or grey-scale. Some of these features can be locked.
Preconfigured drivers can be applied during print queue management operations or exported to disk
as standalone INF driver install file sets.
All drivers installed onto remote hosts by HP Web Jetadmin are installed using INF driver install file
sets. They are not installed with any additional software such as utilities or toolboxes.
Adding a driver
This functionality can be found in the Print Management view in the Available Drivers task module.
From here, drivers INF install file sets can be uploaded into the HP Web Jetadmin host. These drivers
can then be installed onto remote hosts through either a print queue Edit… or New… within the Print
Queues task module or, through the Create Print Queue wizard.
Preconfiguring a driver
1. In the left navigation pane, click Print Management at the bottom of the screen.
In the Print Management - Common Tasks task module, click Pre-configure driver.
The Driver Pre-configuration wizard is started with the Select driver page displayed.
26 Chapter 4 Print queue and print driver management using HP Web Jetadmin V10 ENWW