HP UPD - System Administrator's Guide HP UPD 5.6.5

●
Standard TCP/IP Port?
●
HP Standard Port Monitor?
RAW or LPR?
How are IP addresses distributed to your printers?
●
If static IP addresses are distributed, how are they reserved (DNS, DHCP reservation, BOOTP)?
●
Are printers set to DHCP, BOOTP, or Manual when configuring the IP address?
Ports and protocols
●
Is SNMP enabled in your environment across all subnets?
◦
If not, please describe the subnets where SNMP is disabled and if it is possible to enable SNMP.
●
What versions of SNMP (SNMP v1, v2, v3, other) are enabled in your network infrastructure?
●
Verify that "Get Community" names values are consistent.
◦
Bi-directional communication – between the HP UPD and printer – is required to gather product-
specific configuration information.
●
Make sure mDNS broadcasts and IP multicast services are allowed on the network for the HP UPD to
discover products.
◦
In dynamic mode, the HP UPD will only discover products within the same subnet when Search for
network printers is selected.
●
Activate the mDNS protocol on the printer/product using the HP Embedded Web Server (EWS).
●
Make sure a firewall or router is properly configured to allow the HP UPD to communicate over the
necessary network ports.
Table H-1 Network Ports used by the HP UPD
Port Type Service Used by
161 udp SNMP HP UPD
53 tcp DNS query HP UPD
5353, 5354 udp Multicast DNS HP UPD
80 tcp HTTP HP UPD, HP MPA server,
HP EWS
9100 tcp Print Data HP UPD, Printer
Print server environment
Please fill out this section for each server to be migrated.
Print server information
How many current print servers are in production in your current environment?
Is there a print server for each location or are there regional print servers?
214 Appendix H HP UPD deployment worksheet ENWW