Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Appendix C 231
Ignite-UX System Administration
Section 1: Installation of Ignite-UX Server Software
Section 1: Installation of Ignite-UX
Server Software
NOTE Ignite-UX is a replacement for the Net-Install product. If your server
contains the Net-Install bundle (HPUX-Install product), Ignite-UX will
require that the NetInstall bundle be removed (using swremove), or that
you touch the file /tmp/okay_to_remove_net_install before loading
Ignite-UX, in which case loading Ignite-UX will automatically remove
the NetInstall software.
Ignite-UX Server System Requirements:
HP-UX Version:
It is recommended that the Ignite-UX server be running at least HP-UX
10.20. It is supported on any HP-UX 10.x version of the operating
system. Only 10.10 and later versions of HP-UX are supported as a
DHCP server which Ignite-UX takes advantage of.
Disk Space:
Ignite-UX will be loaded under the directory /opt/ignite. The data files
Ignite-UX creates will be placed under /var/opt/ignite. Ignite-UX
installation will require ~75 MB of disk space. You will probably need
additional space available under /var/opt/ignite for archive and software
depot storage.
NFS Server:
The Ignite-UX server requires NFS to be configured and working. The
Ignite-UX installation will add lines to the /etc/exports file, and run
exportfs.
tftp:
Ignite-UX will transfer some of its files using tftp. The minimum
directories needed by tftp are set up in the /etc/inetd.conf file.
Others may need to be added if you place configuration scripts in
non-standard locations.