Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

232 Appendix C

Ignite-UX System Administration

Section 1: Installation of Ignite-UX Server Software

Load the Ignite-UX software

You should load one or more Ignite-UX release versions. They are

organized as bundles corresponding to the release that you

wish to load on your target systems. For example, if you

wish to load HP-UX 10.20 onto systems you should load the

Ignite-UX-10-20 bundle. You can multiple releases if desired

To load this software use the swinstall command.

For example to load Ignite-UX to load HP-UX 10.20 execute the

following command:

swinstall -s /dev/rmt/0m Ignite-UX-10-20

This assumes you are load Ignite-UX from a tape drive that is

referenced by the device ﬁle at /dev/rmt/0m.

Edit Default Search Path

In your login scripts, add /opt/ignite/bin to your default search

path:

# export PATH=${PATH}:/opt/ignite/bin

Initial Ignite-UX Server Conﬁguration

The majority of the Ignite-UX server conﬁguration is performed by the

product installation post-process procedures, but there are a few

site-speciﬁc conﬁguration steps you will need to perform. These are

centered around the speciﬁcation of available IP addresses and

hostnames.

You can note that the Ignite-UX installation has added 2 services to your

/etc/inetd.conf ﬁle; tftp, and instl_boots.

Step 1) Run the Ignite-UX user interface

Enter the following:

# /opt/ignite/bin/ignite

NOTE You will get a warning screen stating no clients exists. In this situation,

this is normal since you really do not have any clients waiting.