Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Appendix C 235
Ignite-UX System Administration
Section 1: Installation of Ignite-UX Server Software
You may wish to de-select the “Ask for customer information”
checkbox, as this installation information is more geared to HP and HP
distributor-partner manufacturing.
Step 3) Starting the Installation Process
There is nothing that needs to be done to the target system to allow it to
use Ignite-UX.
If the target system is currently running any version of HP-UX 9.x, 10.x,
or later, the target system can be remotely controlled by the Ignite-UX
server. The Ignite-UX bootsys command can be used to perform a
target system shutdown, and re-set the target networking parameters
after the OS installation.
If the target system is not currently running HP-UX, then a manual
network boot will need to be performed on the target. Reboot the target,
press ESC to interrupt the boot process, and then perform the network
boot from the Ignite-UX server:
> boot lan.15.2.72.150 install
where the above IP address is the IP address of the Ignite-UX server.
Note that this process and command may be slightly different on your
target system, depending on the age of your hardware. You’ll need to be
familiar with your system boot commands.