Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

248 Appendix C
Ignite-UX System Administration
Section 3: Automatic Installation
The easiest way to create the “config” file is to use one already built by
IUX. If you’ve previously installed a system (it’s best to use one from a
similar system to your target,) you can find a config file in the
/var/opt/ignite/clients/history/<LLA> directories. Use this as
the basis for your new file. Copy it to the following:
/var/opt/ignite/clients/<LLA>/config
Edit its contents to correspond to your new system.
Here is an example config file:
cfg “HP-UX B.11.00 archive”=TRUE
_hp_cfg_detail_level=”ipvs”
#
# Variable assignments
# init _hp_disk_layout=”Whole disk (not LVM) with HFS”
init _hp_pri_swap=68304K
init _hp_root_disk=”2/0/1.5.0”
init _hp_sec_swap=0K
init _hp_root_grp_disks=1
init _hp_root_grp_striped=”NO”
init_hp_locale=”SET_NULL_LOCALE”
init_hp_keyboard=”PS2_DIN_US_English”
init _hp_default_final_lan_dev=”lan0”
init _hp_boot_dev_path=”2/0/1.6.0”
#
# Software Selections
# init sw_sel “golden image”=TRUE
init sw_sel “English”=TRUE
#
# System/Networking Parameters
# hp_custom_sys+={“Current System Parameters”, “Original
Defaults”}
init _hp_custom_sys=”Current System Parameters”
_hp_custom_sys help_text “Final System/Networking Parameters”
(_hp_custom_sys==”Current System Parameters”)
{
final system_name=”hpfcnjm2” final ip_addr[“lan0”]=”15.2.75.14”