Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Appendix C 261
Ignite-UX System Administration
Section 6: Using Ignite-UX Across Gateways
system_name will cause set_parms not to run, so all other needed system
info (timezone, routes, etc.) should probably be set along with
system_name.
5. Run: instl_adm -f fs_cfg
This applies the changes to the INSTALLFS file.
6. Copy /opt/ignite/boot/* files to the 9.05 boot helper’s /opt/ignite/boot
directory.
NOTE Any further changes MUST be done on the server system and copied over
to the helper system. The 9.0X instl_adm command does have the 10.X
functionality.
To perform an installation to a different machine, repeat steps 4, 5, and
6. For a subsequent runs, only the file “INSTALLFS” needs to be copied
over to the boot helper machine in step 6.
To Perform the Install on the Target:
Boot up the target machine to the boot admin menu, and type a line
similar to the following (for example):
boot lan.15.1.50.57 install
where “15.1.50.57” is replaced by the IP address of the HELPER
machine. If there’s only 1 install server available on the subnet, then just
typing “boot lan install” should work. The exact string to type is
somewhat machine dependent.
At that point, the install should proceed, controlled from the server by
default.