Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

60 Chapter 3
Installing From Media
Booting the Target System
Newer Workstation
Boot Help Menu:
Command Description
Auto [boot|search] [on|off] Display or set auto flag
Boot [pri|alt|scsi.addr] [isl] Boot from primary, alternate or SCSI
Boot lan[.lan_addr] [install] [isl] Boot from LAN
Chassis [on|off] Enable chassis codes
Diagnostic [on|off] Enable/disable diagnostic boot mode
Fastboot [on|off] Display or set fast boot flag
Help Display the command menu
Information Display system information
LanAddress Display LAN station addresses
Monitor [type] Select monitor type
Path [pri|alt] [lan.id|SCSI.addr] Change boot path
Pim [hpmc|toc|lpmc] Display PIM info
Search [ipl] [scsi|lan [install]] Display potential boot devices
Secure [on|off] Display or set security mode
When you see this screen, do the following:
1. Type search Enter.
2. If the device (tape or CD-ROM) is identified in the list shown by the
search command, proceed with the following steps. Otherwise, check
the device and cable connections and repeat the search.
3. Type the following:
boot scsi.x
Use the SCSI address of the boot device for x.
4. If you see the following prompt, respond with "n".
Interact with IPL (y or n)?
(The bottom selections may not appear unless you hold down ESC).
Older Workstation
Boot Menu:
Older HP 9000 Workstations display a menu similar to the following:
Figure 3-2
b) Boot from specified device
s) Search for bootable devices
a) Enter Boot Administration mode
x) Exit and continue boot sequence
?) Help
Select from menu: