Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Chapter 3 61
Installing From Media
Booting the Target System
When the actions menu shown above appears, do the following:
• Press s Enter, to start a search for bootable devices.
Older Workstation
Search Results
=========================================================================
Searching for Devices with Bootable Media.
To terminate search, press and hold the ESCAPE key.
Device Selection Device Path Device Type and Utilities
P0 scsi.6.0 HP 2213A
IPL
P1 scsi.3.0 HP HP35480A
IPL
P2 scsi.0.0 TOSHIBA CD-ROM XM-3301TA
IPL
Enter boot selection, (h)elp, or e(x)it:
===============================================================================
You will see a list of "Pn" selections, as above.
If your boot device does not appear in the search list, do the following:
1. Check the hardware.
2. Press x Enter.
3. Type s Enter to initiate another search.
4. At the prompt "Enter boot selection", enter the "Pn" device
selection for the device containing your install media.
If you know the SCSI address of the device beforehand, you can skip the
search and simply type the following at the "Select from menu"
prompt:
b scsi.x
Time Note (Booting
from Media)
Loading the Ignite-UX install utility from media on a workstation should
take 3 to 5 minutes. After this you will be ready to go to “After Selecting
Boot Paths (Workstation and Server)”for the procedure to interact with
the rest of the utility to load the remainder of your system.