Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Chapter 3 63
Installing From Media
Booting the Target System
Newer Server Search
Results
================================================================
Searching for potential boot device.
This may take several minutes.
To discontinue, press any key.
Path Number Device Path Device Type
- - -
P0 56/52.0 (dec) Seq. record access media
P1 56/52.3 (dec) Seq. record access media
P2 56/52.4 (dec) Random access media
P3 56/52.6 (dec) Random access media
Main Menu: Enter command or menu >
======================================================================
For example, type "bo pn" where "pn" is the path number for the install
device shown in the search output. You can also specify the device by the
hardware path, such as "56/52.0", in place of the path number.
Booting Server For Models 8x7, 845, 835, 870, and other older HP 9000 Servers, you will
see a boot display like the following:
Figure 3-3
================================================================
Console path = 56.0.0.0.0.0.0 (dec)
38.0.0.0.0.0.0 (hex)
Primary boot path = 52.2.0.0.0.0.0 (dec)
34.00000002.0.0.0.0.0 (hex)
Alternate boot path = 52.0.0.0.0.0.0 (dec)
34.0.0.0.0.0.0 (hex)
64 MB of memory configured and tested.
Autoboot from primary path enabled.
To override, press any key within 10 seconds.
Boot from primary boot path (Y or N)?> n
Boot from alternate boot path (Y or N)?>
Enter boot path, command, or ?>
================================================================
1. Turn on the system.