Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

66 Chapter 3
Installing From Media
Booting the Target System
-----------------------------------------------------------------
PDC Firmware Version Information
PDC_ENTRY version 3.1.0.29
POST Revision: 3.1.4.0
OBP Fieldtest Release 3.1.0.29, compiled 97/06/19 16:33:50(2)
SPP_PDC version 1.1.7.2
-----------------------------------------------------------------
Proc type Proc# Proc Rev Speed State Dcache Icache
---------- ----- -------- ------- ------- ------- -------
HP,PA82000 0 4.0 200 MHz Active 2048 KB 2048 KB
HP,PA82000 1 4.0 200 MHz Active 2048 KB 2048 KB
HP,PA82000 2 4.0 200 MHz Active 2048 KB 2048 KB
HP,PA82000 9 4.0 200 MHz Active 2048 KB 2048 KB
HP,PA82000 10 4.0 200 MHz Active 2048 KB 2048 KB
HP,PA82000 11 4.0 200 MHz Active 2048 KB 2048 KB
2048 MB memory installed
Primary boot path = 5/2:0.2.0
Alternate boot path = 15/3
Console path = 15/1
Keyboard path = 15/1
[*** Manufacturing (or Debug) Permissions ON ***]
System is HP9000 V2000 series
Autoboot and Autosearch flags are both OFF or we are in HP core mode.
Processor is entering manual boot mode. ... ...
If the system is set to perform auto-boot, you will see the following:
Processor is starting the autoboot process.
To discontinue, press any key within 10 seconds....
Press any key, at this point. You will see the following display:
(The mnemonics that you would enter for commands are in capital
letters.)