Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Chapter 3 73

Installing From Media

Using the Ignite-UX Interface

===========================================================================

User Interface and Media Options

This screen lets you pick from options that will determine if an

Ignite-UX server is used, and your user interface preference.

Source Location Options:

[ * ] Media only installation

[ ] Media with Network enabled (allows use of SD depots)

[ ] Ignite-UX server based installation

User Interface Options:

[ * ] Guided Installation (recommended for basic installs)

[ ] Advanced Installation (recommended for disk and filesystem management)

[ ] Remote graphical interface running on the Ignite-UX server

Hint: If you need to make LVM size changes, or want to set the

final networking parameters during the install, you will

need to use the Advanced mode (or remote graphical interface).

[ OK ] [ Cancel ] [ Help ]

================================================================================

• Select the Source-Location of installation, by typing an "*" in the box.

• Select among the User Interface options to designate where you

intend to control the installation from. A Remote graphical interface

assumes that you have an Ignite-UX server conﬁgured and available.

NOTE If you only wish to access an SD depot over the network, then you should

choose Media with Network enabled.... You will then be able to specify

the SD depot later during the media install.

The third selection requiring a network server be conﬁgured and

available.

• Select Guided Installation. This has the following characteristics:

• Instructions for each procedure.

• "Mainstream" conﬁguration.

• Default disk layout (e.g., no detailed LVM formatting).