HP Instant Capacity User's Guide for versions B.07.x

Cell Board Instant Capacity
Accidental Activation of an Instant Capacity Cell Board
Chapter 6102
Accidental Activation of an Instant Capacity
Cell Board
If you inadvertently activate an Instant Capacity cell board, you can
de-activate it by following this two step procedure:
Step 1. Set the cell board’s use-on-next-boot flag to “n” (no) using the
parmodify command
Step 2. Perform a reboot of the nPartition
Example 6-4 De-activating a cell board in cabinet 0, slot 5, nPartition 3
For example, changing the use-on-next-boot flag to “n” on the Instant
Capacity cell board in cabinet 0, slot 5, in nPartition 3 can be
accomplished via the following command:
/usr/sbin/parmodify -p 3 -m 0/5::n:
The “n” in the above command line sets the cell board’s
use-on-next-boot flag to “no” and causes the cell board to not
participate in the nPartition when it is booted.
See the HP System Partitions Guide for details about adding and
configuring cells in nPartitions.