HP Instant Capacity User's Guide for versions B.07.x

Instant Capacity Manpages
iCOD (5) Manpage
Appendix C 161
3) If asset reporting is to be used, execute the
icod_notify command (see icod_notify (1M)) to send
an asset report to HP, root, and to the specified e-mail
address. HP will respond to the asset report by sending
a confirmation e-mail to the specified e-mail address.
Receipt of the confirmation e-mail verifies that e-mail
communication with HP is established.
Codewords
Prior to activating iCOD components, a Right-to-Use (RTU) codeword
must be applied to the system. After an enablement fee has been paid to
HP for every iCOD component that is to be activated, RTU codewords are
made available through the HP iCOD portal
(http://www.hp.com/go/icod/portal).
Codewords are applied to the system using the icod_modify command.
After an RTU codeword has been applied to the system, the iCOD
component can be activated by using the icod_modify command (if
activating processors), or other commands including parmodify (see
parmodify (1M)) and parmgr (see parmgr (1M)), depending on the type of
iCOD component.
Software Removal
The iCOD software cannot be removed because other software products
depend on iCOD software to approve configuration changes to the
system.
Contractual Status Of iCOD Processors
Information about the iCOD components (inactive processors, cells, and
memory for which an enablement fee has not been paid) on a system can
be obtained by executing the icod_stat command. This command also
provides information about the amount of temporary capacity
presently in use, and the projected expiration of the temporary
capacity.