HP Instant Capacity User's Guide for versions B.07.x

Getting Started
Instant Capacity Requirements
Chapter 226
HP-UX 11i v2 Requirements
For Versions
B.07.x on
HP-UX 11i v2
The following software is required for Instant Capacity versions B.07.x
on HP-UX 11i v2:
❏ HP-UX 11i v2 May 2005 update, or later
❏ iCOD software bundle B9073BA (versions B.07.x) — installed
automatically when the HP-UX 11i v2 Operating Environment (OE)
is installed
❏ The kernel configuration must include the diag2 module
❏ WBEM B8465BA bundle (version A.01.05 or higher)
❏ nPartition provider NPar bundle (version B.11.23.01.04 or higher,
available from the OE)
❏ If you have a virtual partitioned environment, the Virtual Partitions
software (bundle T1335BC) must be version A.04.01 or greater
NOTE On HP-UX 11i v2 systems, updated firmware may be required by either
or both of the NPar or Virtual Partitions software, as documented for
these products.
Your Instant Capacity system is ordered and shipped with all of the
above software. In the event your system’s operating system is
reinstalled or installed with Ignite-UX, ensure that the above software
requirements are satisfied.
E-mail Requirements
For some configurations, previous versions of the Instant Capacity
software (prior to B.07.x) required e-mail connectivity to HP in order to
send asset reports as encrypted e-mail messages. Instant Capacity
versions B.07.x no longer requires e-mail connectivity or asset reporting,
however, you may choose to configure it because it can be useful for
viewing complex-wide asset information at the Utility Pricing Solutions
portal (http://www.hp.com/go/icod/portal).
Note that for a new installation, asset reporting is on by default so that
unless you turn asset reporting off or configure the e-mail connectivity,
error messages may be logged when the software attempts to send asset