HP Instant Capacity User's Guide for versions B.07.x

Installing and Uninstalling Instant Capacity Software
Installing Instant Capacity Software
Chapter 344
Installing Instant Capacity Software
Factory Integrated
Systems
You do not need to install the Instant Capacity software if your
processors and software were ordered with your HP enterprise server.
The Instant Capacity software was already installed by HP prior to
delivery. You can use the following command to verify that the software
is installed and configured:
/usr/sbin/swverify B9073BA
You sh ou ld see Verification succeeded. in the output of the
swverify command.
IMPORTANT The Instant Capacity software is automatically installed when the
HP-UX 11i v2 or 11i v1 Operating Environment (OE) is installed. If any
partition in the system has version B.07.x software installed, then all
partitions in the system with Instant Capacity software must be running
version B.07.x software. That is, there cannot be a mix of different
versions of the Instant Capacity software in the same system. See
“Upgrading to Instant Capacity versions B.06.x or B.07.x Software” on
page 122 for details of upgrading the software from a version previous to
B.07.x.
For HP-UX you should not need to install the Instant Capacity software;
however, if you do, it is available from the following media/locations:
• HP software depot (HP web site:
http://www.hp.com/go/softwaredepot)
• May 2005 HP-UX 11i v2 Operating Environment (OE) media
• May 2005 HP-UX 11i v2 Applications Software media
• September 2005 HP-UX 11i v1 Operating Environment (OE) media
• September 2005 HP-UX 11i v1 Applications Software media
The following instructions can be used to install versions B.07.x: