Managing Superdome Complexes: A Guide for HP-UX System Administrators

Overview of the Superdome System Environment
HP-UX 11i Features for Superdome Servers
Chapter 130
rad Command Output on Superdome Servers
This section covers the rad command’s output on Superdome servers. For
complete details refer to the rad (1M) manpage.
NOTE When adding or replacing I/O cards use the equivalent SAM procedures,
when possible, rather than using rad.
See also the sam (1M) and rad (1M) manpages.
On HP Superdome servers, the rad command reports PCI card slot
details as shown in the following example output. The rad command
reports details showing the PCI slot ( cabinet-bay-chassis-slot ) and
the corresponding HP-UX hardware path ( cell/sba/lba/device ).
For details on HP-UX hardware paths, refer to “HP-UX Hardware Paths
on HP Superdome Systems” on page 27.
# rad -q
Driver(s)
Slot Path Bus Speed Power Occupied Suspended Capable
0-0-1-0 0/0/0 0 33 On Yes No No
0-0-1-1 0/0/1/0 8 33 On Yes No Yes
0-0-1-2 0/0/2/0 16 33 On Yes No Yes
0-0-1-3 0/0/3/0 24 33 On Yes No Yes
0-0-1-4 0/0/4/0 32 33 On Yes No Yes
0-0-1-5 0/0/6/0 48 66 On Yes N/A N/A
0-0-1-6 0/0/14/0 112 33 On No N/A N/A
0-0-1-7 0/0/12/0 96 33 On No N/A N/A
0-0-1-8 0/0/11/0 88 33 On Yes No Yes
0-0-1-9 0/0/10/0 80 33 On No N/A N/A
0-0-1-10 0/0/9/0 72 33 On No N/A N/A
0-0-1-11 0/0/8/0 64 33 On Yes No Yes
0-1-3-0 2/0/0 0 33 On Yes No No
0-1-3-1 2/0/1/0 8 33 On Yes No Yes
0-1-3-2 2/0/2/0 16 33 On Yes No Yes
0-1-3-3 2/0/3/0 24 33 On Yes No Yes
0-1-3-4 2/0/4/0 32 33 On No N/A N/A
0-1-3-5 2/0/6/0 48 33 On No N/A N/A
0-1-3-6 2/0/14/0 112 66 On Yes N/A N/A
0-1-3-7 2/0/12/0 96 33 On No N/A N/A
0-1-3-8 2/0/11/0 88 33 On Yes No Yes
0-1-3-9 2/0/10/0 80 33 On No N/A N/A
0-1-3-10 2/0/9/0 72 33 On No N/A N/A
0-1-3-11 2/0/8/0 64 33 On Yes No Yes
#
Cabinet 0, Bay 0, Chassis 1, Slot 3
(rad slot notation: 0-0-1-3)
Cell 2, SBA 0, LBA 6, Device 0
(HP-UX hardware path: 2/0/6/0)