Managing Superdome Complexes: A Guide for HP-UX System Administrators

Superdome Console and Service Interface
Accessing the Superdome Guardian Service Processor (GSP)
Chapter 2 39
Procedure: Logging in to a GSP
This procedure is for logging in to a the Guardian Service Processor
(GSP) for a Superdome complex.
Step 1. Use the HP-UX telnet command on a remote system to connect to the
GSP utility hardware for the Superdome server.
You can connect directly from the command line, for example:
• telnet sdome-g
or run telnet first, and then issue the open command:
• telnet
telnet> open sdome-g
All telnet commands and escape options are supported while you are
connected to the GSP. See the telnet(1) manpage for details.
(On non-HP-UX platforms such as various Windows environments you
can instead use an alternate telnet program.)
Step 2. Log in using your GSP account name and password.
• GSP login: Accountname
GSP password: Password
Step 3. Use the GSP menus and commands as needed and log out when done.
To log out, select the “Exit Connection” menu item from the GSP Main
Menu (enter X at the GSP> prompt).
You also can terminate a GSP login session by issuing the telnet escape
key sequence ^] (type: Control-right bracket) and entering close at the
telnet> prompt.
NOTE You should log out of any consoles and GSP menus before terminating
your GSP telnet session.