Managing Superdome Complexes: A Guide for HP-UX System Administrators

Superdome Console and Service Interface
Using GSP Commands
Chapter 246
Using GSP Commands
This section summarizes the commonly used GSP commands, and
provides details about the various categories of GSP commands. See
Chapter 2 for details on using GSP commands to manage and configure
Partitions.
To return to the GSP main menu from the command menu, enter the MA
command.
All users connected to a Superdome server’s GSP command menu share
access to the menu.
Only one command can be issued at a time. For each command issued,
the command and its output are displayed to all users currently
accessing the GSP command menu.
Some commands are restricted and are available to GSP users who have
Admin or Operator privileges only. You can issue any command that is
valid at your access level by entering the command at the GSP
command menu prompt (GSP:CM>).
When you list commands using the HE command, the commands are
shown in the four following categories:
• Service commands—Support boot, reset, TOC, and other common
service activities.
• Status commands—Give command help and system status
information.
• System and access configuration commands—Provide ways to
configure system security and console and diagnostic settings.
• Manufacturing commands—Allow trained HP service personnel to
perform various tasks.
The following sections give more details about the available commands.