Managing Superdome Complexes: A Guide for HP-UX System Administrators

Superdome Console and Service Interface
Using GSP Commands
Chapter 250
GSP Command Menu: System and Access
Configuration Commands
The System and Access Configuration commands available from the
GSP command menu provide ways to configure system security and
console and diagnostic settings.
These commands also enable you to specify a default partition for your
current GSP session, and allow for modifying some Superdome complex
configuration settings.
Most of the system access commands are for use by HP service and
support personnel.
Some of these commands are restricted. Users with an “Admin” access
level can use all System and Access Configuration commands.Users with
an “Operator” or “Single Partition User” access level can issue a subset of
the System and Access Configuration commands, as the following table
indicates.
Table 2-4 GSP Command Menu: System and Access
Configuration Commands
Access Level(s) System /
Access
Config
Command
Description
Administrator AR Configure the automatic system restart.
Administrator,
Operator
CA Configure asynchronous and modem parameters.
Administrator,
Operator
CC Initiate a complex configuration.
Administrator DATE Set the time and date.
Administrator DC Reset parameters to default configuration.
Administrator,
Operator
DI Disconnect remote or LAN console.
Administrator DL Disable LAN console access.