Managing Superdome Complexes: A Guide for HP-UX System Administrators

Superdome Console and Service Interface
Using GSP Commands
Chapter 252
GSP: Manufacturing Commands
You normally should not need to use any of the various manufacturing
commands available from the GSP command menu.
CAUTION The manufacturing commands are provided for use by Hewlett-Packard
service personnel only.
Table 2-5 GSP Command Menu: Manufacturing Commands
Manufacturing
Command
Description
CM Modify clock margin.
MFG Enter the manufacturing mode. (Administrator
only.)
RD Read utility processor memory.
RU Reset USB device.
VT Display the trace buffer of a firmware entity.
WF Write FRU ID data of an entity.
WR Write utility processor memory.