Managing Superdome Complexes: A Guide for HP-UX System Administrators

Managing the Overall Complex

Viewing / Setting the Complex Hardware Conﬁguration

Chapter 3 75

The following example shows using the PS command to list the PM and

CLU ﬁrmware versions for the UGUY utilities board in cabinet

number 1.

BCH Follow this procedure to use the partition’s BCH interface to list the PDC

version installed on active cells within the partition.

Step 1. Access the BCH interface for the partition to which the cells are

assigned, and access the BCH information menu.

From the BCH main menu, enter IN to access the BCH information

menu. (If you are not at the BCH main menu, enter MA to go to the main

menu.)

Step 2. Issue the BCH information menu’s FV command to list the PDC version

installed on all active cells in the partition.

To list both the PDC and PDHC ﬁrmware versions for a cell, use the GSP.

GSP:CM> PS

This command displays detailed power and hardware configuration status.

The following GSP bus devices were found:

+----+-----+-----------+----------------+-----------------------------------+

| | | UGUY | Cells | 0 | 1 | 2 | 3 |

| # | GSP | CLU | PM |0 1 2 3 4 5 6 7 |0 1 2 3 |0 1 2 3 |0 1 2 3 |0 1 2 3 |

+----+-----+-----+-----+----------------+--------+--------+--------+--------+

| 0 | * | * | * |* * * * * * * * | * * | | | |

| 1 | | * | * |* * * * * * * * | * * | | | |

| 8 | | * | * | | * * | * * | | |

You may display detailed power and hardware status for the following items:

B - Cabinet (UGUY)

C - Cell

G - GSP

I - Core IO

Select Device: b

Enter cabinet number: 1

HW status for SD64000 compute cabinet #1: NO FAILURE DETECTED

PM firmware rev 6.8, time stamp: FRI SEP 22 16:16:19 2000

CLU firmware rev 6.10, time stamp: WED SEP 06 20:56:50 2000

GSP:CM>