Support Plus User Guide HP-UX 11i v1, September 2005

Support Plus User Guide HP-UX 11i v1
Setting Up Access to Support Plus
Chapter 118
Setting Up Access to Support Plus
If you mounted the CD on the system that is the target for the patch or
diagnostic installation, then you have access to the Support Plus data;
proceed to “Installing the Selected Bundles” on page 20. Otherwise,
continue with the steps on this page.
Sharing Support Plus with Remote Systems
To enable direct access from one or two other systems, you must register
a depot on the Support Plus CD using the swreg command. For example,
to register the HWEnable11i depot, assuming the Support Plus CD is
mounted to /cdrom, use the following steps.
1. Register the depot:
swreg -l depot /cdrom/HWEnable11i
2. Install the bundles. See “Installing the Selected Bundles” on page 20.
3. Disable remote access by unregistering the depot:
swreg -u -l depot /cdrom/HWEnable11i
NOTE You cannot access or register HP-UX 11.x depots from HP-UX 10.20
systems.