HP-UX TN3270 Administration Guide
Installing TN3270
Loading the Product Files
Chapter 2 25
Loading the Product Files
After determining that you have the hardware, software and host
requirements for the TN3270 product, you will need to load the TN3270
product file, as follows:
Step 1. Ensure that you have a CD-ROM drive attached to your system to read
the product file. This drive should be configured on your system with an
entry in the /dev directory.
Step 2. Use the HP-UX tool swinstall to load the TN3270 product (load
J2636BA for Series 800 Systems or J2637BA for Series 700 Systems).
Refer to the man pages of the HP-UX system for instructions on how to
do this.
Step 3. Once you have loaded the TN3270 product file, you can use the swverify
command to:
• verify whether TN3270 is compatible with the hosts on which the
software was installed
• verify that all dependencies (prerequisites) are beingmet for installed
software
• report missing files and check all file attributes including
permissions, files types, siz, checksum, mtime, link source and other
major/minor attributes.
The command syntax for swverify is:
swverify [-f file] [-s source] [-t target]
Only use the swverify command through the command line interface.