9000

Chapter 1 25

HP FDDI/9000 Resources

HP-UX Manual Reference Pages

While installing, conﬁguring, or troubleshooting EISA or HSC

FDDI/9000, you may need to refer to any of the following online manual

reference pages (man pages) for useful HP-UX operating system or EISA

or HSC FDDI commands. To display a man page, type the following at

the system prompt:

man <command name>

NOTE The fddilink utility displays the operating statistics of an EISA or

HSC FDDI network, while the fddiif utility collects operating

statistics on the EISA or HSC FDDI adapter. These utilities are

described in Chapter 5 “Troubleshooting.”

• arp(1M) displays a list of addresses associated with a speciﬁed host.

The arp -a command displays all current Address Resolution

Protocol (ARP) entries.

• ifconfig(1M) can be run to manually bring up the Net-Interface or

to verify if the Net-Interface is up.

• ioscan(1M) scans system hardware, usable I/O system devices, or

kernel I/O system data structures as appropriate, and lists the

results.

• lanadmin(1M) is a local area network administration program that

allows you to display statistics for the card and, if necessary, to reset

the card.

• lanscan(1M) displays information about LAN adapters that are

successfully bound to the system.

• linkloop(1M) veriﬁes network connectivity through the Data Link

Layer.

• mksf(1M) or insf (1M) creates device ﬁles.

• netstat(1) provides network statistics and information about

network connections. netstat -i displays inbound and outbound

statistics.

• nettl(1M) captures and controls network tracing and logging

information. netfmt(1M) formats the nettl tracing and logging

binary ﬁles.