Installing and Administering HP EISA FDDI/9000 and HP HSC FDDI/9000

Chapter 2 37
Installing the HP EISA FDDI/9000 Adapter
Connecting the Adapter to the Network
Figure 2-3 SAS MIC Connection
2. Recheck your connections, ensuring that each connector is plugged
into the correct Tx or Rx receptable or jack, as discussed in the
previous step.
3. Reconnect the AC power cord to the system and the power source.
4. Power up the system.
The adapter runs a self-test automatically. During power up, system
messages may appear regarding the absence of the EISA
configuration for the adapter. You can safely ignore these messages
since the EISA configuration happens automatically after the adapter
software is installed.
Now that your adapter is installed, continue to Chapter 4,
“Configuring and Verifying HP EISA and HSC FDDI/9000.”
Tx Rx
EISA connector
MIC port
(1) Yellow LED
(2) Yellow LED
(3) Green LED
(4) Green LED
MIC port on adapter
Key located in slot
MIC
To M port of
single-attachment
concentrator
Faceplate