Installing and Administering Internet Services

Chapter 8 299
Configuring gated
Troubleshooting gated
trace_on: Tracing to "/tt" started
Tracing flags enabled: general
parse: conf.tt:4 Interface not found at ’lan3’
parse_parse: 2 parse errors
Exit gated[15941] version @(#)Revision: 1.0 based on Cornell GateD R3_5Beta_3
Interface Configuration without strictintfs Option
Specified.
The following configuration references a non-existent
interface, but does not include the strictintfs option.
traceoptions "tt" general;
interfaces {
interface lan0 lan1 lan3 passive ;
} ;
rip yes ;
The following is the tracing output that is produced when gated is
started with this configuration:
trace_on: Tracing to "/tt" started
Tracing flags enabled: general
inet_routerid_notify: Router ID: 15.13.119.134
The results of this same command can also be found in the gated_dump
file, although not as easily. In the following segment of a gated_dump
file, the interface is listed as passive in the interface policy statement at
the bottom of the example.
Interfaces:
lo0 Index 1 Change: <> State: <Loopback>
Refcount: 2 Up-down transitions: 0
127.0.0.1
Metric: 0 MTU: 4072
Refcount: 4 Preference: 0 Down: 120
Change: <> State: <Up Loopback Multicast>
Subnet Mask: 255.255.255.255
proto: RIP State: <NoIn NoOut>
lan0 Index 2 Address 802.2 8:0:9:1b:da:1f Change: <> State: <>
Refcount: 2 Up-down transitions: 0
15.13.119.134
Metric: 0 MTU: 1436
Refcount: 6 Preference: 0 Down: 120
Change: <> State: <Up Broadcast Multicast NoAge>