NetWare Client for DOS and MS Windows User Guide

4-13
Preparing to Install or Upgrade the NetWare Client Software
Setting Up for Installation from a Network Directory
The volume and directory are SYS:PUBLIC\CLIENT\DOSWIN for DOS
and MS Windows.
The following procedure shows you how to map a drive to the appropriate
volume and directory.
Procedure
1 Map the next network drive to SYS:PUBLIC by typing
MAP N SYS:PUBLIC <Enter>
NOTE: This mapping might already be set up as a search drive in a login script for your client
workstation. Use the MAP utility to view a list of existing drive mappings. If a drive
mapping already exists for the SYS:PUBLIC directory, then proceed to Step 2.
2 Change to the network drive that is mapped to the PUBLIC subdirectory.
For example, if you mapped network drive G:, type
G: <Enter>
3 Change to the CLIENT\DOSWIN directory under SYS:PUBLIC for the client
files by typing
CD CLIENT\DOSWIN <Enter>
4 Either continue preparing the installation program or begin installing the client
software by going to one of the following sections:
• To modify the installation configuration file for your particular setup, see
“Editing the INSTALL.CFG File” for more information.
• To use the NetWare Client installation program, see Chapter 5, “Installing or
Upgrading NetWare Client Software,” for more information.