NetWare Client for DOS and MS Windows User Guide

5-14
Installing or Upgrading NetWare Client Software
Running the NetWare Client Installation Program
These procedures correspond with Step 5 on the installation program opening
screen.
A box appears, prompting you to modify the value settings for your network
board. The following are some of the main options available:
• Base I/O port
• Hardware interrupts
• Media frame type
There are numerous other options available, depending on your network board
type and driver.
Refer to the help at the bottom of the installation program screen for information
about an appropriate value setting for each option.
Network Board Type Procedure
Supported by NetWare and displayed
in the list
(ODI LAN drivers only. Use an
existing LAN driver for network
boards with dedicated IPX™ drivers
only.
Select the “Other drivers” option in the
“Network Board” menu and direct the
installation program to the path where
the driver is located.)
1 Press <Enter> to select a LAN driver from the
NetWare Client for DOS and MS Windows Disk 1.
If prompted, replace the current diskette with the
NetWare Client for DOS and MS Windows ODI
LAN Drivers.
2 Display the list by pressing <Enter> again.
3 Move through the list by using the arrow keys or the
PgDn key.
4 Select the driver you want to install and press
<Enter>.
Supported by NetWare but not
displayed in the list
(If you are using dedicated IPX LAN
drivers, replace with the appropriate
ODI LAN driver for your network
board.
Select the “Other drivers” option in the
“Network Board” menu and direct the
installation program to the path where
the driver is located.)
1 Press <Enter> and then replace NetWare Client for
DOS and MS Windows Disk 1 with the driver
diskette that was included in your network board
kit.
2 Display the list by pressing <Enter> again.
3 Move through the list by using the arrow keys or the
PgDn key.
4 Select the driver you want to install and press
<Enter>.