NetWare Client for DOS and MS Windows User Guide

5-22

Installing or Upgrading NetWare Client Software

Installing for MS Windows for Workgroups

If you are running the NetWare Client software on client workstations

running MS Windows for Workgroups (WFWG), you should complete this

additional setup before loading the NetWare Client software.

The additional setup required for MS Windows for Workgroups is notifying

the WFWG software of the LAN driver type you want to use. You can use

ODI LAN drivers provided in this kit.

Prerequisites

Ensure the following before running the MS Windows for Workgroups

software:

• A working copy of the MS Windows for Workgroups software is installed on

each workstation you want to run with the NetWare Client software

• The NetWare Client software is installed or upgraded on each client workstation

running the MS Windows for Workgroups software

NOTE: If you install the NetWare Client software on top of a copy of MS Windows for

Workgroups that has the “Microsoft Windows Network” disabled, the Network

Setup program within MS Windows for Workgroups will not recognize the NetWare

Client software.

Ensure that the WINNET= and MULTINET= settings in the [Network] section of the

SYSTEM.INI file are set to WINNET=NOVELL/00040000 and

MULTINET=NETWARE4 for running the NetWare DOS Requester software.

• The NetWare Client software is loaded and running, with a successful connection

in DOS to the network or a NetWare server

Procedure

To set up and run the NetWare Client software on client workstations

running MS Windows for Workgroups, complete the following steps:

1 Load the MS Windows for Workgroups software.

The following error message appears: