NetWare Client for DOS and MS Windows User Guide

5-23
Installing or Upgrading NetWare Client Software
Installing for MS Windows for Workgroups
“Networking functionality will not be available. Your
network adapter or protocols may not be configured
properly. Run Network Setup to check adapter and
protocol settings.”
2 To continue, choose “OK.”
3 In the “Network” group, choose the “Network Setup” icon.
4 From the “Network Setup” dialog box, choose “Drivers.”
The “Network Drivers” dialog box appears. MS Windows for Workgroups
requires you to select a LAN driver compatible with ODI for your network
board.
a Remove any existing LAN drivers from the dialog box by selecting a LAN
driver and choosing “Remove.”
When prompted to make sure you want to remove the selected LAN drivers,
choose “Yes.”
b Choose “Add Adapter.”
c From the “Add Network Adapter” dialog box, select the appropriate ODI
LAN driver for your network board.
The Setup program might prompt you to direct it to the location of the
correct ODI LAN driver. The correct LAN driver should exist in the
NetWare Client directory you selected during installation of the NetWare
Client software.
d Setup the appropriate frame type for your network.
The NWLINK.386 file is a 32-bit IPX/SPX™ compatible transport Vxd
used by MS Windows for Workgroups. It defaults to the Ethernet_802.3
frame type.
Software such as the RCONSOLE utility and other utilities that run in an MS
Windows DOS box might fail if the frame type setting is incorrect for your
network.
To change the default frame type for the NWLINK.386 file, select “IPX/SPX
Compatible Transport” or “IPX/SPX Compatible Transport with NetBIOS,”
and then choose “Setup.” Then, select “Frame Type” and change the value to
the desired frame type.
e Exit the “Network Drivers” dialog box, by choosing “OK” and then “Exit.”
Your NetWare Client software installation is now completed.