NetWare Client for DOS and MS Windows User Guide

10-11
Setting Up Source Routing Support for a Token-Ring Network
Modifying the DOS System and NetWare Client Configuration Files
odi_lan_driver
route
ipxodi
vlm
Replace path with the directory where the ROUTE.COM and NET.CFG files are
found. The ROUTE.COM file cannot execute unless it can access the NET.CFG
file in the proper directory path.
Replace odi_lan_driver with the name of the ODI LAN driver that your
workstation is using. For example, Novell provides the NTR2000.COM file or
the LANSUP.COM file.
The command to load the ROUTE.COM file should be added after the
odi_lan_driver file, but before the protocol stack you are using, such as the
IPXODI.COM file.
Add any necessary command line parameters after the route statement.
Use the following parameters for configuring the ROUTE.COM driver:
BOARD=number
CLEAR
DEF
GBR
MBR
NODES=number
REMOVE=number
NOTE: If two frame type are used on your network, load the ROUTE.COM file twice in the
STARTNET.BAT file. You must load ROUTE.COM once for each
BOARD=number statement used.
See Chapter 3, “Command Line Parameters Reference,” in NetWare Client
for DOS and MS Windows Technical Reference for descriptions and details
on how to use command line parameters for ROUTE.COM.
1 Save your changes and exit the ASCII text editor.