NetWare Client for DOS and MS Windows User Guide

11-10
Configuring Client Workstations for Desktop SNMP Services
Modifying DOS System and NetWare Client Configuration Files
If the time zone is not set in your workstation’s environment, traps for SNMP
might report an incorrect time.
5 Save and exit.
Modifying the NET.CFG File
The following modifications to the NET.CFG file are required for each client
workstation that you want to load the Desktop SNMP software on.
• Add the necessary lines in the NET.CFG file to load and support the Desktop
SNMP software.
• Set the “TRAP TARGET” address of the NetWare Services Management (NSM)
consoles or other SNMP-based managers.
See “Sample NET.CFG File for Desktop SNMP Services” for an example.
By default, Desktop SNMP services are not enabled when you install the
NetWare Client software. To enable Desktop SNMP services, complete the
following procedure.
Procedure
1 Ensure that the Desktop SNMP files are copied to the NetWare Client directory
(the default is C:\NWCLIENT).
2 Modify the NET.CFG file to load the Desktop SNMP .VLM files.
To load the Desktop SNMP .VLM file suite, modify the NET.CFG file on your
client workstation in either of the following two ways:
• To load the Desktop SNMP and the NetWare DOS Requester software, add
the following lines to the NET.CFG file in the order given:
netware dos requester
vlm = wssnmp.vlm
vlm = wstrap.vlm
vlm = wsreg.vlm
vlm = wsasn1.vlm
vlm = mib2if.vlm
vlm = wsdrvprn.vlm
vlm = mib2prot.vlm
• To load only Desktop SNMP, without the NetWare DOS Requester modules,