PCI Token Ring Administrator's Guide

Token Ring Interface Card Statistics
IEEE 802.5 Token Ring MIB
Appendix A114
Please refer to the latest Release Notes for software
patches that may be required to support particular
configurations of this product.
Speed An estimate of the current bandwidth of the interface
in bits per second. For interfaces which do not vary in
bandwidth or for those where no accurate estimates
can be made, this object contains the nominal
bandwidth.
Station Address The interface address at the protocol layer immediately
below the network layer in the protocol stack. For
interfaces which do not have such an address, such as
serial line, this object contains an octet string of zero
length.
Administration Status
The desired state of the interface. This parameter is set
to up(1) and is not configurable
Operation Status The current operational state of the interface. It will
have one of the following values.
Last Change The value of SysUpTime at the time the interface
entered its current operational state. If the current
state was entered prior to the last reinitialization of the
local network management subsystem, then this object
contains a zero value. This is not implemented in PCI
Token Ring.
Inbound Octets The total number of octets received on the interface,
including framing characters.
Inbound Unicast Packets
The number of subnetwork-unicast packets delivered
to a high-layer protocol.
Table A-2 Interface Operational States
up(1) Ready to pass packets
down(2) Not operative (bad card or cable)
testing(3) In test mode