PCI Token Ring Administrator's Guide

Installing Token Ring
Step 3: Loading Token Ring Software
Chapter 1 31
Step 3: Loading Token Ring Software
This section assumes that the board has been installed using the
instructions found in the previous section (Step 2). Follow the steps
below to load Token Ring software using the HP-UX swinstall program.
Model 712, HP 9000 EISA, or Series 800 HP-PB
Systems
1. Log in as root.
2. Insert the software media (tape or disk) into the appropriate drive.
3. Run the swinstall program using the command:
swinstall
This opens the Software Selection Window and Specify Source
Window.
4. Change the Source Host Name if necessary, enter the mount point of
the drive in the Source Depot Path field, and activate the OK button
to return to the Software Selection Window. Activate the Help button
to get more information.
The Software Selection Window now contains a list of available
software bundles to install.
5. Highlight the Token Ring software for your system type.
6. Choose Mark for Install from the ‘‘Actions’’ menu to choose the
product to be installed.
7. Choose Install from the ‘‘Actions’’ menu to begin product
installation and open the Install Analysis Window.
8. Activate the OK button in the Install Analysis Window when the
Status field displays a Ready message.
9. Activate the Yes button at the Confirmation Window to confirm that
you want to install the software. swinstall displays the Install
Window.