PCI Token Ring Administrator's Guide

Installing Token Ring
Step 3: Loading Token Ring Software
Chapter 132
View the Install Window to read processing data while the software
is being installed. swinstall loads the fileset, runs the control scripts
for the fileset, and builds the kernel. When the Status field indicates
Ready, activate the OK button and the Note Window opens.
Estimated time for processing: 3 to 5 minutes.
10. Activate the OK button on the Note Window to reboot the system.
The user interface disappears and the system reboots.
11. When the system reboots, check the log file in
/var/adm/sw/swinstall.log and /var/adm/sw/swagent.log to
make sure the installation was successful.
12. HP 9000 EISA only: Go to “Configuration for (older) EISA Cards” in
Chapter 2.
PCI Systems
Preparation
You can install PCI Token Ring software from your application media
during a normal system operation where:
1. The system is already booted up for operation.
2. The system is up during the installation.
3. Single-user state is not required.
For patch requirements for 10.20 and 11.0, refer to the Release Notes. A
core LAN products patch is required prior to installing the software and
an additional patch is required prior to using SAM.
Installation using “swinstall”
1. Log in as root.
2. Insert the software media (tape or disk) into the appropriate drive.
3. Run the swinstall program using the command:
swinstall
This opens the Software Selection Window and Specify Source
Window.