PCI Token Ring Administrator's Guide

Installing Token Ring
Step 3: Loading Token Ring Software
Chapter 1 33
4. Change the Source Host Name if necessary, enter the mount point of
the drive in the Source Depot Path field, and activate the OK button
to return to the Software Selection Window. Activate the Help button
to get more information.
The Software Selection Window now contains a list of available
software bundles to install.
5. Highlight the Token Ring software for your system type.
6. Choose Mark for Install from the ‘‘Actions’’ menu to choose the
product to be installed.
7. Choose Install from the ‘‘Actions’’ menu to begin product
installation and open the Install Analysis Window.
8. Activate the OK button in the Install Analysis Window when the
Status field displays a Ready message.
9. Activate the Yes button at the Confirmation Window to confirm that
you want to install the software. swinstall displays the Install
Window.
View the Install Window to read processing data while the software
is being installed. swinstall loads the fileset, runs the control scripts
for the fileset, and builds the kernel. When the Status field indicates
Ready, activate the OK button and the Note Window opens.
Estimated time for processing: 3 to 5 minutes.
10. Activate the OK button on the Note Window to reboot the system.
The user interface disappears and the system reboots.
Follow-up
1. We recommended that you do a reboot after configuring
/etc/rc.config.d/pcitrconf, but you can execute
/sbin/rc2.d/S315pcitr start to prevent a reboot.
2. After reboot, check what(1) string on the kernel. Execute:
what /stand/vmunix | grep Token
You should see the following on HP-UX 10.20 systems:
A5783A/J1644AA HP PCI Token Ring <version> (<release>)
<date>
You should see the following on HP-UX 11.x systems: