PCI Token Ring Administrator's Guide
Token Ring Resources
HP-UX Manual Reference Pages
Chapter 3 59
HP-UX Manual Reference Pages
While installing, configuring, or troubleshooting Token Ring, you may
need to refer to any of the following on-line manual reference pages (man
pages) for useful HP-UX operating system or Token Ring commands. To
display a man page, type the following at the system prompt: man
<command name>. For example, man arp.
• arp(1M) displays and modifies the Internet-to-station address
mapping tables used by the Address Resolution Protocol.
• eisa_config(1M) interprets information stored in configuration files
and uses it to configure system resources needed to properly interact
with EISA cards on HP 9000 EISA workstations. You should also use
eisa_config to set the EISA Token Ring card link speed and cable
connector type.
• hosts(4) contains database that contains a single line entry for each
host name entry.
• ifconfig(1M) assigns an address to a network interface and
configures and displays network parameters.
• ioscan(1M) scans system hardware, usable I/O system devices, or
kernel I/O system data structures as appropriate, and lists the
results.
• lanadmin(1M) resets or reports the status of the LAN card
including Token Ring.
• lanscan(1M) displays information about LAN cards that are
successfully bound to the system.
• linkloop(1M) verifies network connectivity through the Data Link
Layer (OSI Layer 2).
• netfmt(1M) formats common tracing and logging binary files.
• netstat(1) provides network statistics and information about
network connections.
• nettl(1M) logs network events and trace packets as they enter and
exit the Token Ring driver.