PCI Token Ring Administrator's Guide

Token Ring Resources

Manual Installation and Conﬁguration

Chapter 3 69

NOTE If full-duplex is enabled and the requirements of g.1 through

g.3 above are satisﬁed, the adapter will sense and conﬁgure

itself to 100 Mb/s operation regardless of the speed setting.

This is not supported.

A 100 Mb/s switch port cannot support 4/16 Mb/s operation.

Manually setting 4 or 16 Mb/s when A5783A is connected to

a 100 Mb/s switch port is not supported.

Connecting A4930A to a 100 Mb/s switch port is not

supported.

Starting with B.11.00.06, a new option has been added to

/etc/rc.config.d/pcitrconf: PCITR_RIF. This can be

used to enable/disable source routing on a per interface basis

and can be set to ENABLE or DISABLE. The default is

ENABLE. Note that SAM support for this option is not yet

available.

SAM conﬁguration of any parameter will overwrite RIF

information. RIF conﬁguration should be done manually

after SAM conﬁguration of other parameters.

2. Conﬁgure the interfaces in/etc/rc.config.d/netconf if necessary.

Reboot after modifying pcitrconf and netconf. Alternatively,

execute /sbin/rc2.d/S315pcitr start after modifying pcitrconf

and netconf, but before executing /sbin/rc2.d/S340net start or

using ifconfig(1M).

When conﬁguring pcitrconf and netconf, please note that white

space is not permittedon either side of theequals symbol (“=”) within

the conﬁguration ﬁles.