Transport Optional Upgrade Release (TOUR) 2.5 Release Notes

Installing TOUR 2.5

TOUR A.02.05 Transport Optional Upgrade Release for B.11.11

Step 3. To verify that there were no errors during the TOUR 2.5 installation, run the

following command:

# swverify TOUR

If TOUR 2.5 is successfully installed, the following message is displayed:

Verification succeeded

Additional Important Information

This section includes other relevant information about installing and using TOUR 2.5.

Installing or Removing Transport or PPP Patches

After installing TOUR 2.5, you cannot remove or install additional transport patches. If you

need to add or remove a transport patch, you must first remove TOUR 2.5. Separate patches

for TOUR 2.5 (distinct from transport patches) are available, as needed.

If you attempt to install a transport patch after installing TOUR 2.5, the system displays the

following message:

NOTE: The Transport Optional Upgrade Release (TOUR) is already installed.

HP-UX cumulative ARPA Transport patches can NOT be installed because

installing them would corrupt TOUR. TOUR has a separate support mechanism

(patches and new versions). Please use this for updates to TOUR. If you must

install this patch PHNE_

nnnnn

, then first remove TOUR.

If you attempt to remove a transport patch after installing TOUR 2.5, the system displays the

following message:

ERROR: The Transport Optional Upgrade Release (TOUR) is already installed.

HP-UX cumulative ARPA Transport patches can NOT be removed because removing

them would corrupt TOUR. If you must remove this patch PHNE_

nnnnn

, then first

remove TOUR.

If you attempt to install or remove a PPP patch, similar messages are displayed.

Compatibility Between TOUR 2.5 and HP-UX IPSec

TOUR 2.5 is compatible only with HP-UX IPSec (J4256AA) version A.02.00 or greater. TOUR

2.0 (or later) is a software requirement for HP-UX IPSec (J4256AA) version A.02.00 or

greater. TOUR 2.5, TOUR 2.4, TOUR 2.2, and TOUR 2.0 are not compatible with earlier

versions of HP-UX IPSec. If you try to install TOUR 2.5 on a system that has an earlier

version of HP-UX IPSec (J4256AA) the following error message will be displayed: