Manualshelf

Using the HP DTC Manager/UX

ManualsBrandsHP ManualsSoftwareHP-UX 11i v1 Networking Software
161162163164165166167168169170
163
About dtccheckip
13
About dtccheckip
The dtccheckip command is used as a troubleshooting tool to check for duplicated
IP addresses.
If you have added a DTC or modified information about LAN address configuration,
dtccheckip is automatically run after the termination of dtcconfig.
When the Exit DTCconf function key is pressed in the dtcconfig menu, you are
asked whether you want to quit or not. If you reply “yes”, this ends the execution of
the dtcconfig command and executes the dtccheckip command.
You will see the following messages:
• Check for duplicated IP addresses in progress ...
• Check for duplicated IP addresses finished.
Only if you have duplicated IP addresses, the following message will appear:
Note “*” is used to show duplicated IP addresses, but the IP addresses of all DTCs are
listed.
The duplicated IP addresses should be modified to ensure there are no problems
with the DTCs.
You can also use the dtccheckip command in isolation to diagnose potential
problems with duplicated IP addresses.
Duplicated IP Address DTC Name
* XXX.XXX.XXX.XXX DTC1
* XXX.XXX.XXX.XXX DTC2
YYY.YYY.YYY.YYY DTC3
...
ZZZ.ZZZ.ZZZ.ZZZ DTCn